Nissan
Nissan Parts for the S13, R32, and R33
S13 Cup Holder
S13 Cup Holder
68mm Cup Holder with “Push Push” operation.
Heavy Duty ABS Design, pair it with my DRAKES S13 Vent Housing for best results.
Compatible with OE Vent Housing, REAR CAGE MUST BE REMOVED
DO this at your own risk as I am not liable for damage.
Micro Roller bearings offer smooth operation, and a cabinet latch makes for a strong springing action when you push in the vent fascia.
The cup holder is easily installed by aligning the Vent Housing Diverter into the horizontal position and then sliding in the side detents.
The spring loaded side detents will either snap into the OE plastic housing or sit comfortably in the DRAKES M4 Bearing swivels
The amount of action needed is easily adjusted with a M4 grub screw on the rear.
Two inset M3 screws offer security of the cup holder onto the vent housing, for anti theft purposes (ONLY available on the DRAKES Housing).
Micro bearings and multi part assembly allow for very precise repeatable operation.
